Alvarez System 600T MK II 소유자 매뉴얼 - 페이지 2

{카테고리_이름} Alvarez System 600T MK II에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alvarez System 600T MK II 4 페이지. Acoustic preamp / eq

페이지 인쇄

CONTENTS

Internal Chassis Controls / Connections ..................................2

Diagram of System 600T MK II ..............................................3

Digital Tuner Function..............................................................5

Specifications............................................................................6

CONGRATULATIONS!

You have chosen the finest acoustic

Preamp/Eq System available.

The Alvarez System 600T MK II Preamp/Eq is designed to offer the

finest acoustic guitar tone reproduction available. The System 600T MK

II provides a broad range of sonic control, mixing capability for different

combinations of piezo/magnetic/microphone transducers, and features an

on-board digital chromatic tuner. We recommend that you take a few

minutes to read this manual in order to familiarize yourself with the

many advanced features and capabilities of the System 600T MK II.

This guitar is equipped with a piezo pickup mounted under the bridge

saddle. This pickup is connected to the PIEZO input of the System 600T

MK II, and the guitar will perform perfectly with this pickup/preamp

combination. The System 600T MK II is capable of mixing an additional

Alvarez ACM50 condenser mic or an Alvarez ASP50 MK II sound hole

pickup with the piezo pickup for a wider range of sonic possibilities.

Some features of the System 600T MK II will only operate when an

additional pickup/microphone is used.

S Y S T E M 6 0 0 T M K I I OW NE R S G UI DE

INTERNAL CHASSIS

CONTROLS/CONNECTIONS

With the chassis removed from the mounting ring, you will notice

connections on the rear panel, next to the battery compartment. The

connection marked (1) OUTPUT is for the signal being sent to the

output jack. There are two INPUT jacks, labeled (2) PIEZO and

(3) AUX. The PIEZO input should already be connected to the

under-saddle bridge pickup. The AUX input is included for use with an

additional Alvarez ASP50 MK II sound hole pickup or an Alvarez

ACM50 condenser microphone. Power for the ACM50 is supplied

through the ring of the AUX jack.

On the side of the chassis are two trim pots, labeled (4) LOW and

(5) HIGH. These trim pots are used to adjust the gain of the BASS

and TREBLE sliders on the front panel. These

adjustments are used to "fine tune" the System

600T MK II to the sonic characteristics of the

particular guitar being used.

BATTERY

COMPARTMENT

The System 600T MK II is powered by

a 9 Volt battery mounted in the bottom of

the control chassis. Access the battery

compartment by removing the two front panel

thumb screws and lifting the chassis from the

mounting ring. Further, the System 600T

MK II can be phantom powered on

instruments equipped with an optional XLR

switching jack via the 3-pin connector on the

rear of the chassis.

Refer to the front panel diagram on the next page

to familiarize yourself with the various control

functions of the Alvarez System 600T MK II.