DNP DS620A Schnellstart-Handbuch - Seite 5

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Drucker DNP DS620A herunter. DNP DS620A 8 Seiten. Clearing a cutter jam

6. Check for any scraps of paper or other debris near the cutter. Using tweezers, carefully remove any scraps

you find. If you are unable to locate or remove a jam in the cutter gear, proceed to Method 2.

7. Remove any objects from the cutter path.

8. Verify that the printer is level and that four corners of the bottom are touching a level surface. Gently shake

the printer to verify that the printer is firmly set on the surface.

9. Plug the power and USB cables into the back of the printer and power the printer ON.

10. Reload the paper. When the paper is loaded properly, the printer beeps twice. If the two beeps are not

heard, proceed to Method 2.

11. Close the printer. It should initialize and produce the blank test cuts. If the printer does not initialize,

proceed to Method 2.

12. Print a test page. If the test page does not print properly, proceed to Method 2.

Method 2: Cleaning the Cutter Assembly

NOTE: This is an advanced printer cleaning procedure; please read through the instructions thoroughly before

proceeding.

This procedure does require a small Philips screwdriver, magnetic if possible to prevent losing the screws.

1. Turn the printer OFF and unplug the power cable and USB cables from the back of the printer.

2. Use the blue handle on the front of the printer to open the media compartment drawer.

3. Press the blue release lever on the left side of the media drawer to open the paper compartment.

4. Remove the two small screws on the bottom of the cover.

5 of 8

Troubleshooting

DNP Imagingcomm America Corporation