Dog trace d-control 440 Benutzerhandbuch - Seite 10
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Haustierpflegeprodukt Dog trace d-control 440 herunter. Dog trace d-control 440 19 Seiten. Electronic vibration training collar
Seite drucken
Switching the receiver ON/OFF
To turn the receiver ON/OFF (or for programming the transmitter with the receiver) is used a magnetic
switch, marked with the red target on the receiver. The receiver is activated when the magnet in bottom
of the transmitter, is enclosed to the red target on the receiver.
Switching ON
Move the red target of the receiver towards the bottom of the transmitter for 1 second (see the Fig.).
The red LED indicator of the receiver will lit up, afterwards the green LED indicator will start blinking.
The receiver is prepared for use.
Switching OFF
When switching OFF, follow the same steps as when switching ON.
Move the red target of the receiver towards the bottom of the transmitter - the green LED indicator of
the receiver will lit up, afterwards the red LED indicator will lit up.
IMPORTANT: When turning the receiver ON hold
the red target of the receiver close to the red tar-
get of the transmitter for about 1 second. When
the targets are close to each other for longer than
5 seconds the receiver will switch to the pairing
(programming) mode of the transmitter with the
receiver. This programming mode is indicated by
alternate flashing of the red and green LED indica-
tor. If this occurs, follow the chapter Programming
(pairing) the transmitter with the receiver.
To extend the battery life, it is necessary to turn off the
receiver and transmitter whenever the training of your
dog is finished. If you do not use the device for a long
time, we recommend you to remove the batteries out.
10
The position where the receiver is turned ON/OFF
and where the transmitter is being
paired with the receiver.