Dog trace d-control 440 Benutzerhandbuch - Seite 11
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Haustierpflegeprodukt Dog trace d-control 440 herunter. Dog trace d-control 440 19 Seiten. Electronic vibration training collar
Seite drucken
Programming (pairing) of the transmitter and the receiver
Each transmitter has its own RF operational code. The pairing needs to be done to make the receiver
and transmitter operate together. When you receive a new set the pairing is done by manufacturer.
The pairing is done, when you need to use different transmitter or receiver (for example when bought
a new one).
The transmitter is made for training of two dogs, so you can pair it with two receivers. Use the button
/
to choose the right dog.
IMPORTANT: Before programming is started make sure that noone else uses his/her d–control in
your neighbourhood. Your receiver could randomly receive the code from another transmitter and
get paired with it. If this happens, program your receiver once again, using your transmitter.
Pairing of the button
1. Turn ON your transmitter.
2. The receiver has to be turned OFF.
3. Press the button
4. Move the lower part of the transmitter to the target on your receiver (see the pic. on page 10) and
hold in position so the green LED is steadily lit. After approximately 5 seconds it will switch to the
pairing / programming mode, indicated by flashing of the red and green LED at the same time (4x).
5. Then take your transmitter away from the receiver and press down the audible beep tone button
on your transmitter. If you hear the beep tone the pairing has been successful.
Pairing of the button
Press the button
(this can be followed when you use d-control 440 with a new purchased receiver or when you
purchased d-control 442).
with the first receiver
for the first receiver choice.
with the second receiver
for the second receiver choice and follow the steps as for the first receiver above
11