- ページ 11

ペットケア製品 Dog trace d-control 440のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Dog trace d-control 440 19 ページ。 Electronic vibration training collar

Programming (pairing) of the transmitter and the receiver

Each transmitter has its own RF operational code. The pairing needs to be done to make the receiver

and transmitter operate together. When you receive a new set the pairing is done by manufacturer.

The pairing is done, when you need to use different transmitter or receiver (for example when bought

a new one).

The transmitter is made for training of two dogs, so you can pair it with two receivers. Use the button

to choose the right dog.

IMPORTANT: Before programming is started make sure that noone else uses his/her d–control in

your neighbourhood. Your receiver could randomly receive the code from another transmitter and

get paired with it. If this happens, program your receiver once again, using your transmitter.

Pairing of the button

1. Turn ON your transmitter.

2. The receiver has to be turned OFF.

3. Press the button

4. Move the lower part of the transmitter to the target on your receiver (see the pic. on page 10) and

hold in position so the green LED is steadily lit. After approximately 5 seconds it will switch to the

pairing / programming mode, indicated by flashing of the red and green LED at the same time (4x).

5. Then take your transmitter away from the receiver and press down the audible beep tone button

on your transmitter. If you hear the beep tone the pairing has been successful.

Pairing of the button

Press the button

(this can be followed when you use d-control 440 with a new purchased receiver or when you

purchased d-control 442).

with the first receiver

for the first receiver choice.

with the second receiver

for the second receiver choice and follow the steps as for the first receiver above