- ページ 9

ペットケア製品 Dog trace d-control 440のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Dog trace d-control 440 19 ページ。 Electronic vibration training collar

Receiver preparation

Battery insertion and replacement

1. Screw out 4 screws from the battery cover using a cross-head screwdriver and remove the lid.

2. Insert the lithium CR2 3V battery into the battery compartment with a correct polarity (according

to the polarity indicated with the "+" symbol in the battery com-

partment – see the Fig.). A wrong polarity may damage the unit.

When you insert the battery for the first time, or if the battery is removed

longer than a few tens of minutes, you will hear an audible beep tone

indicating the correct installation of the battery.

Note: When you replace the battery quickly, you may not hear the

audible beep tone of the collar.

3. Make sure that the rubber seal is clean and correctly seated in its

groove. Clean any dirt from the seal.

4. Put the battery cover of the receiver back and screw in the 4 screws

adequately.

Checking the receiver battery status

The status of the battery is indicated by LED indicators on the side of the receiver. (see chapter:

Product description – Receiver)

The batterry is fully charged – when switched on, green LED is flashing.

The battery is low – when switched on, green and red LED is flashing.

When the battery is low or flat, insert a new CR2 3V lithium battery into the receiver. Check the correct

function.

Battery polarity indicator