Dog trace d-control 440 Manuel de l'utilisateur - Page 9
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Dog trace d-control 440. Dog trace d-control 440 19 pages. Electronic vibration training collar
Imprimer la page
Receiver preparation
Battery insertion and replacement
1. Screw out 4 screws from the battery cover using a cross-head screwdriver and remove the lid.
2. Insert the lithium CR2 3V battery into the battery compartment with a correct polarity (according
to the polarity indicated with the "+" symbol in the battery com-
partment – see the Fig.). A wrong polarity may damage the unit.
When you insert the battery for the first time, or if the battery is removed
longer than a few tens of minutes, you will hear an audible beep tone
indicating the correct installation of the battery.
Note: When you replace the battery quickly, you may not hear the
audible beep tone of the collar.
3. Make sure that the rubber seal is clean and correctly seated in its
groove. Clean any dirt from the seal.
4. Put the battery cover of the receiver back and screw in the 4 screws
adequately.
Checking the receiver battery status
The status of the battery is indicated by LED indicators on the side of the receiver. (see chapter:
Product description – Receiver)
The batterry is fully charged – when switched on, green LED is flashing.
The battery is low – when switched on, green and red LED is flashing.
When the battery is low or flat, insert a new CR2 3V lithium battery into the receiver. Check the correct
function.
Battery polarity indicator
9