Clockaudio CW 9000 Gebrauchsanweisung - Seite 8

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Mikrofonanlage Clockaudio CW 9000 herunter. Clockaudio CW 9000 11 Seiten. Uhf ppl wireless microphones

Seite drucken

4.7 CU-2 Intelligent Battery Management System

Charging Current

1.25A

Charging Time

6 hours (Ni-MH. 2700mAH)

Indicators

Red LED charging

Green LED charging complete

Power Supply

Input 90-260V AC

Output 12VDC 1.25A

Dimensions

L 125mm (4.93") W 125mm (4.93") H 63mm (2.48")

Weight

282g (9.95oz)

• Processor controlled

• Built-in active monitoring circuitry

• Pulse charging system

• Temperature sensor

• Two dedicated compartment for charging two CW9004-T, CW9005-T or CW9006-T

C LO C K A U D I O

P A G E 1 4

CW9004T - CW9005T - CW9006T SWITCHING INSTRUCTIONS

The following instructions are a step to step guide of how you can programme the switch to the

function you require:

1. Whilst holding down the function switch, power up the base by switching on the power

switch located on the underside of the base.This enables you to enter programming

mode. Note both bases require 9 to 48 volts phantom power to operate.

2. You will notice the LED flashes on and off for approximately 2 seconds to tell you that

programming mode has been selected.

3. At each stage of programming the base will tell you what functions have already been

stored by the LED flashing the appropriate numbers of times. See the table below for a

quick reference guide.

Programme

Description

Switch Type

Switch Action

By pressing the switch once programme option 1 shall be selected and the LED will flash

according to which option is stored (either once for Momentary or twice for Latching) and

likewise for programme option 2 for PTT or PTM.

You are able to change the switching operation by following the step by step guide.

Latching (Normally On)

This is the default setting, the switch has a latching operation and the microphone is live as soon

as the base is powered. Should the default setting be cleared perform the following actions:

1. Press the switch once the LED will flash once, then press the switch twice the LED will

flash twice. Once you have performed this step the switch is set for Latching operation.

2. For Normally On press the switch twice, the LED will flash twice, then again press the

switch twice the LED will flash twice. Wait for approximately 5 seconds and the switch

function will be set into the bases memory.

Latching (Normally Off)

The microphone requires the switch to be pressed to become live. For programming follow step

one from above and then for normally off press the switch twice, the LED will flash twice, then

press the switch once the LED will flash once. Wait for approximately 5 seconds and the switch

function will set into the bases memory.

Option 1

Option 2

Momentary

Latching

PTT (Normally Off)

PTM (Normally On)

C LO C K A U D I O

P A G E 1 5