Clockaudio CW 9000 Інструкція з експлуатації - Сторінка 8
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Мікрофонна система Clockaudio CW 9000. Clockaudio CW 9000 11 сторінок. Uhf ppl wireless microphones
Друкувати сторінку4.7 CU-2 Intelligent Battery Management System
Charging Current
1.25A
Charging Time
6 hours (Ni-MH. 2700mAH)
Indicators
Red LED charging
Green LED charging complete
Power Supply
Input 90-260V AC
Output 12VDC 1.25A
Dimensions
L 125mm (4.93") W 125mm (4.93") H 63mm (2.48")
Weight
282g (9.95oz)
• Processor controlled
• Built-in active monitoring circuitry
• Pulse charging system
• Temperature sensor
• Two dedicated compartment for charging two CW9004-T, CW9005-T or CW9006-T
C LO C K A U D I O
P A G E 1 4
CW9004T - CW9005T - CW9006T SWITCHING INSTRUCTIONS
The following instructions are a step to step guide of how you can programme the switch to the
function you require:
1. Whilst holding down the function switch, power up the base by switching on the power
switch located on the underside of the base.This enables you to enter programming
mode. Note both bases require 9 to 48 volts phantom power to operate.
2. You will notice the LED flashes on and off for approximately 2 seconds to tell you that
programming mode has been selected.
3. At each stage of programming the base will tell you what functions have already been
stored by the LED flashing the appropriate numbers of times. See the table below for a
quick reference guide.
Programme
Description
1
Switch Type
2
Switch Action
By pressing the switch once programme option 1 shall be selected and the LED will flash
according to which option is stored (either once for Momentary or twice for Latching) and
likewise for programme option 2 for PTT or PTM.
You are able to change the switching operation by following the step by step guide.
Latching (Normally On)
This is the default setting, the switch has a latching operation and the microphone is live as soon
as the base is powered. Should the default setting be cleared perform the following actions:
1. Press the switch once the LED will flash once, then press the switch twice the LED will
flash twice. Once you have performed this step the switch is set for Latching operation.
2. For Normally On press the switch twice, the LED will flash twice, then again press the
switch twice the LED will flash twice. Wait for approximately 5 seconds and the switch
function will be set into the bases memory.
Latching (Normally Off)
The microphone requires the switch to be pressed to become live. For programming follow step
one from above and then for normally off press the switch twice, the LED will flash twice, then
press the switch once the LED will flash once. Wait for approximately 5 seconds and the switch
function will set into the bases memory.
Option 1
Option 2
Momentary
Latching
PTT (Normally Off)
PTM (Normally On)
C LO C K A U D I O
P A G E 1 5