Akrobat GALLUS INGROUND Installations- und Benutzerhandbuch - Seite 6
Blättern Sie online oder laden Sie pdf Installations- und Benutzerhandbuch für Zubehör Akrobat GALLUS INGROUND herunter. Akrobat GALLUS INGROUND 20 Seiten. 10ft; 12ft; 13.5ft; 14ft
Attaching the pvc retaining panels
The next step is screwing the PVC retaining
3
wall panels to the frame. You will need the
cross-head screwdriver and gloves. Take one
panel and place it against the outside of the
frame. You will find four holes in the frame and
four holes in the wall panel. Insert and tighten
the four screws to attach the panel tightly to
the frame. Repeat with all remaining panels.
Digging the trampoline pit
Position the frame on the location you chose and mark the position on the ground. It's best to mark
4
out a hole a bit wider than the diameter of your trampoline.
This will make it easier for you to put the frame in and find the right level. Dig the pit to the
following dimensions:
TRAMPOLINE SIZE
Dimension A – Outer hole
10 ft / cca. 305 cm
12ft / cca. 366 cm
13.5ft / cca. 411 cm
14ft / cca. 427 cm
First, dig the outer hole to create a ledge for
your trampoline frame, which needs to be
25cm deep. This is the exact frame height, so
that the safety pad on top of the frame will be
just above the grass level. Continue by digging
the inner hole.
AKROBAT HINT:
It's a relatively easy task to hand dig the hole for smaller size trampolines, but it would be best to hire a
mini digger able to excavate most of the soil and leave you with the finishing touches.
Note: You will need to save some of the soil for later.
6
INSTALLATION AND USER MANUAL - GALLUS INGROUND
Dimension B – Inner hole
204 cm
264 cm
371 cm
387 cm
Dig out in a bowl shape to a depth of 75
cm (10ft & 12ft trampolines), or 90 cm
(13.5ft & 14ft trampolines). The inner hole
should be 40 cm narrower in diameter than
the trampoline, which leaves a 20 cm ledge all
around to place the trampoline.
Dimension C – Total depth
75 cm
75 cm
90 cm
90 cm