Asgard Gladiator Montageanleitung Handbuch - Seite 5

Blättern Sie online oder laden Sie pdf Montageanleitung Handbuch für Zelt Asgard Gladiator herunter. Asgard Gladiator 7 Seiten.

Seite drucken
STEP 16
5
6
PARTS
INSTRUCTION
RUN A BEAD OF SEALENT ALONG THE CONTACT EDGES
PRE ASSEMBLED
OF THE TOP SHROUD.
LONG & SHORT
TOP SHROUDS
LIFT THE SHROUD ONTO THE ROOF ALIGNING THE FIXING
- 5 & 6
HOLES BOTH IN THE, BOTH IN THE ENDS AND ALONG THE
LENGTH OF THE ROOF.
20*
SCREW IN POSITION.
4*
STEP 19
V
PARTS
PREPARE THE ROOF JOINT STRIPS BY RUNNING TWO BEADS OF SEALENT ALONG THE FULL LENGTH OF THE EDGES OF THE FOLDS THAT RUN DOWN THE BACK
ROOF JOINT
OF THE PART AS INDICATED.
STRIPS
40881
THE BEADS OF SEALENT NEED TO BE LARGE ENOUGH TO CREATE AN ADDTIONAL SEAL WHEN THE PLATE IS PUT INTO POSITION BRIDGING
(QUANTITY
THE JOINTS ON THE ROOF.
DEPENDS
UPON NUMBER
OF EXTENSIONS)
STEP 17
19
FIT CABLE
GROMMETS
HEAR.
PARTS
INSTRUCTION
WE ADVISE THAT YOU USE HAND HELD DRIVERS RATHER
LH DOOR
THAN POWER DRIVERS WHEN FIXING THE DOORS .
- 19
IT IS IMPORTANT TO SUPPORT THE DOORS AT ALL TIMES
WHILST FITTING THE SCREWS TO ENSURE CORRECT
RH DOOR
ALLIGNMENT.
- 20
POSITION LH DOOR '19' (NON LOCKING DOOR) SO THAT
25mm DIA
THE HINGES ARE ALLIGNED WITH THE THREADED FIXING
GROMMET
HOLES, SCREW IN POSITION.
(X2)
24*
REPEAT PROCESS WITH RH DOOR '20'
FIT THE 25mm DIA GROMMETS TO THE FRONT SIDE PANELS
(THESE ARE CABLE ACCESS POINTS IF REQUIRED)
INSTRUCTION
STEP 18
REFER TO FRONT
20
SHEET FOR DOOR
ALIGNMENT AND
ANCHORING OF UNIT.
STEP 20
ROOF JOINT PLATE
TRAPPED UNDER
ROOF SHROUDS
PARTS
SLACKEN THE PREFITTED ROOF SHROUDS SUFFICIENTLY ENOUGH TO ALLOW THE ENDS OF THE ROOF JOINT PLATES TO BE PUSHED UP UNDERNEATH THEM.
THE JOINT PLATES SHOULD BE POSITIONED CENTRALLY OVER THE ROOF JOINTS AS SHOWN ON THE DETAIL
RE-TIGHTEN THE SHROUDS TO TRAP THE PLATES.
IF FITTING ONE OR MORE
EXTENSIONS TO YOUR UNIT IT IS
IMPORTANT THAT YOU FIT THE ROOF
JOINT STRIPS ON EACH ADDTIONAL
ROOF SECTION AS SHOWN BELOW.
THE STRIPS ARE ONLY USED
WITH EXTENIONS
THIS MUST BE DONE WHILST
THE SEALENT SECURING THE ROOF
SHROUDS IS STILL SOFT
JOINT STRIP
X
SEALENT
ROOF JOINT
Y
INSTRUCTION
SEALENT