Dolby Laboratories DP591 Schnellstart-Handbuch - Seite 17
Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Medienkonverter Dolby Laboratories DP591 herunter. Dolby Laboratories DP591 19 Seiten. Object authoring tool
Auch für Dolby Laboratories DP591: Schnellstart-Handbuch (9 seiten)
Seite drucken
About this task
Using the audio meters on the DP590, you can monitor either the input channels or the
rendered presentation output channels of the unit. To view the live channels, the client
software must be connected to the physical unit through the assigned IP address.
Procedure
1. In the View menu, select Meters.
The Audio Meters window displays with the assigned PCM inputs and the rendered
presentation outputs on each of the corresponding 64 MADI channels in use.
2. To see the input and output signals at the same time, click both the Inputs and Ouputs
buttons so they are blue. To see only one set of channels at a time, click the button you
want to turn off so that it becomes gray.
3. Use the slider bar at the bottom of the window to view the entire range of channels.
4.11 Connecting to a DP591
Complete the installation process by connecting to a DP591. You must connect to a DP591 if
you want to send metadata as part of the broadcast.
Procedure
1. In the Settings menu, click Metadata Servers Config.
The Metadata Servers window displays.
2. Enter the IP address of your DP591 unit, and then click OK.
4.12 Sending metadata to the DP591
Send metadata from a DP590 to the DP591 to place the presentations in the broadcast
stream.
About this task
After establishing the presentations you want in the DP590, transmit the metadata to the
DP591 for encoding in the broadcast stream.
Note: The first saved presentation is the only one included by default in the metadata
transmission. You must select all other presentations you want to transmit.
Procedure
1. Have a presentation you want to use in the broadcast stream open in the DP590 GUI.
Note: In case the only change you made in a presentation was the presentation's
name, the metadata does not change. To reflect a presentation name change in
metadata you must generate new program ID.
a) To generate new program ID, from the Settings menu, select Set Program ID.
b) Click Generate.
The displayed program UUID and short program ID change.
c) Click OK to confirm the operation.
The window closes and the presentation name change is reflected in the metadata.
2. From the Settings menu, select Bitstream config.
The Bitstream Configuration window displays with your saved presentations, as shown in
this figure.
Dolby DP590 object authoring tool quick-start guide
24 June 2016
4.11 Connecting to a DP591
17