Ashford Jack Montageanleitung Handbuch - Seite 12
Blättern Sie online oder laden Sie pdf Montageanleitung Handbuch für Weben Ashford Jack herunter. Ashford Jack 16 Seiten.
Seite drucken
22. Attach the handle to the crank with a
threading the bolt through the handle and crank and locking it with a
. Then locate crank onto the shaft of warp roller Z and lock
M8 Hex Nut
in place with
6.5 x 40 Cotter Pin
prevent it falling out.
NOTE: The cloth and warp roller must rotate in the direction shown.
3/32 Dome Cap
Harness Hook
M8 x 100 Cup Head Bolt
. Spread the ends of the pin slightly to
23. Your Ashford 8 Shaft Jack Loom has been supplied with Texsolv
Heddles. Each bundle contains 100 heddles which enable you to use
100 per shaft.
Take a bundle of heddles (DO NOT REMOVE THE PINK TIES).
Thread 2 round steel bars through the holes in a shafts, through the
gaps in the top and bottom of the bundles and into the holes in the
other end of the shaft. Then push
the outside of the shaft to lock the steel rod in place.
NOTE: ensure the
the holes so they do not protrude or drag on the nylon guides.
THEN remove the ties and spread the heddles evenly either side of the
centre hole.
The heddles can be used as is or can be cut with sharp scissors. Only
cut after the heddles have been loaded onto the steel rods.
24. Each shaft has holes on both edges of top and bottom rails. The hole
for the jack pin is exactly in the centre of the bottom rail to ensure it
lifts evenly and is marked with a small hole on the front of the shaft.
Do not use this hole for a hook.
Fit one
and secure by pressing a
this by supporting the hook on a corner of a table and pressing firmly
on the dome cap.
by
M8 Hex Nut
M11 Rubber Buffer
into the top rail and the bottom rail of each shaft
Harness Hook
3/32 Dome Cap
Spread the heddles evenly either side
of the Harness Hook and then clip the
stainless steel rods over the hooks. The
hooks prevent the bars from sagging
when being raised or pulling out when
the warp is being advanced.
12
M8 x 100
Cup Head Bolt
into the oval hole in
M11 Rubber Buffer
are pushed right to the bottom of
onto the hook. It is easier to do