Ashford Jack Montageanleitung Handbuch - Seite 14

Blättern Sie online oder laden Sie pdf Montageanleitung Handbuch für Weben Ashford Jack herunter. Ashford Jack 16 Seiten.

Seite drucken

M6 Barrel Nut

(Hidden)

M6 x 16 Washer

M6 x 65 Hex Head Bolt

32. Tie a knot in the

Nylon Cords

approx. 15mm at the end.

NOTE: There are 8 parallel lams and 8

slots in each treadle. After determining

the pattern required, connect the

cord from each lam to the slot in the

treadle directly beneath it. The knots

in the cords locate into the holes in the

underside of the treadles.

M6 x 75 Cup Head Bolt

M6 x 22 Washer

M16 Rubber

Buffer

6 x ½ Pan

Head Screw

M6 Nylock Nut

M6 x 16 Washer

leaving

28. Tap the beater stops into the castle

29. Assemble the beater by joining the sides

30. Place the reed into the groove in the

31. Place the beater in position on the loom

M6 x 16 Washer

M6 x 100

Hex Head Bolt

sides E and EX. Note the lead holes for

the screws face out. Use wood glue if

necessary. Then attach the

to the stops with

Buffer

6 x ½ Pan Head

Screws

Q to the bottom rail R with

Head Bolts

M6 X 16 Washers

. Note the shuttle race faces forward.

Nut

bottom rail R. Secure the top beater rail

S to the sides with

M6 x 75 Cup Head Bolts

and nylon knobs.

M6 x 22 Washers

frame and push a

M6 x 100 Hex Head Bolt

and

through the beater

M6 X 16 Washer

side Q, through the hole in the spacer

block attached to the side A and secure

with

and

M6 X 16 Washer

M6 Nylock Nut

Repeat for side AX

NOTE: Do not tighten bolts, the beater

must move freely.

M16 Rubber

M6 x 65 Hex

and

M6 Barrel