Akron SAM BOOST Schnellstart-Handbuch - Seite 5

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Ausrüstung für die Brandbekämpfung Akron SAM BOOST herunter. Akron SAM BOOST 8 Seiten.

Seite drucken

4. DISPLAY INSTALLATION

□ Remove Original Equipment Pressure Governor

□ Mount SAM BOOST™ Display with Adapter Plate

□ Replace Original Equipment Master Intake & Discharge Pressure Sensors

If Buzzer Included in Kit:

□ Remove Original Equipment Buzzer

□ Install SAM BOOST™ Display Buzzer

If Buzzer NOT Included in Kit:

□ Connect Buzzer into SAM BOOST™ Display

5. WATER TANK COMPONENT INSTALLATION

□ Install Pump Venting Solenoid to 1/4" NPT Port on Discharge Side of Pump

□ Install Check Valve Assembly to Water Tank or Discharge Side of Tank Fill Valve

□ Connect & Route 3/8" Push-On Hose Tubing between Solenoid & Check Valve

□ Locate & Remove OEM Water Tank Sensor

□ Install OEM Water Tank Sensor to SAM BOOST™ Tank Assembly

□ Install SAM BOOST™ Tank Assembly to Water Tank

6. ELECTRONIC MODULE INSTALLATION

□ Mount Matrix & Radio Modules to Valves

• Adapter fits 2.5", 3", or 4" Valves

7. HARNESS INSTALLATION

□ Connect all Harnesses shown on System Layout

□ Connect OEM Power & Ground to SAM BOOST™ Power & Ground

• Do NOT wire to circuit with heavy motor loads (such as primer, foam system)

• Wire to switched power source with 60 AMP protection on positive (+) side

8. WARNING LABEL & PLACARD INSTALLATION

□ Locate & Place Warning Labels where Preconnect Hoses are Deployed

□ Locate & Place Cover Placards over Original Valve Control Push Rods Panel Holes

Sheet: FSG-MNL-00233

SAM BOOST™ WITH SMART NOZZLE N

Refer to FSG-MNL-00232 for complete listing of Safety Hazards & Warnings

Revision 7 / 10 / 2023

QUICK START GUIDE

Page: 4 of 7