Ashly KLR 2000 Benutzerhandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Verstärken Ashly KLR 2000 herunter. Ashly KLR 2000 12 Seiten. Klr series two-channel, high-performance power amplifiers
Auch für Ashly KLR 2000: Spezifikationen (2 seiten)

Seite drucken

Operator Manual – KLR Series Amplifiers

Physical Description

Each model in the KLR-Series is 2RU. The model number is indicated on the left side of the

front panel

Amplifier Front Panel

Mounting Holes – For rack mounting.

Air Inflow Vents – Cool air enters here.

Channel Attenuators – These knobs adjust

the attenuation of the input signal of each

channel from ∞ to 0.

Signal, Clip, and Protect LEDs – Indicates

output level of -30, -20, -10dB, Clip, and

amplifier protect.

Amplifier Rear Panel

1. AC Cord – For connection to the AC mains

2. CH 1, CH 2, Bridged Output Connector – This

connector provides the amplifier's Channel 1, channel 1

and 2, or bridged output.

3. CH 2 Output Connector – This connector provides

the amplifier's Channel 2 output.

4. Air Outflow Vents – Warm air exits here.

5. Gain Switch – The Gain switch sets the gain for both

channels. Gain selections vary between models. Check

specifications for each model.

6. Mode Switch – This switch selects the amplifier's

operating mode (Bridge, Stereo, or Parallel Mono).

Note: KLR 5000 rear panel has different feature locations

(

7. 3-Pin Euroblock Input Connectors – These

connectors are used for balanced or unbalanced input

signals. For parallel mode or bridged mode, use INPUT 1

only.

8. Combination XLR, 1/4" TRS Input Connectors –

These connectors are used for balanced or unbalanced

input signals, and are wired in parallel with the Euroblock

connector.

9. Limiter Switch – This switch engages the limiter.

There is a separate limiter for each channel.

10. HPF Switch – This switch selects the input HiPass

filter to 30Hz, 50Hz, or Off.

Power Switch and LED – Switches the unit on

or off. The KLR 2000, KLR 3200, and KLR

4000 use a switch with a built in mains circuit-

breaker. The KLR 5000 uses a non-breaker

switch and an internal mains fuse instead.

Page - 5

Important Safety

Instructions – 2

Introduction - 3

The KLR Series - 4

Physical Description - 5

Front Panel

Rear Panel

Installation - 6

Troubleshooting - 10

Spec Table - 11

Warranty - 12

)

0611