Ashly KLR 2000 Manuale dell'operatore - Pagina 5

Sfoglia online o scarica il pdf Manuale dell'operatore per Amplificatore Ashly KLR 2000. Ashly KLR 2000 12. Klr series two-channel, high-performance power amplifiers
Anche per Ashly KLR 2000: Specifiche tecniche (2 pagine)

Ashly KLR 2000 Manuale dell'operatore
Operator Manual – KLR Series Amplifiers

Physical Description

Each model in the KLR-Series is 2RU. The model number is indicated on the left side of the
front panel
Amplifier Front Panel
1.
Mounting Holes – For rack mounting.
2.
Air Inflow Vents – Cool air enters here.
3.
Channel Attenuators – These knobs adjust
the attenuation of the input signal of each
channel from ∞ to 0.
4.
Signal, Clip, and Protect LEDs – Indicates
output level of -30, -20, -10dB, Clip, and
amplifier protect.
Amplifier Rear Panel
1. AC Cord – For connection to the AC mains
2. CH 1, CH 2, Bridged Output Connector – This
connector provides the amplifier's Channel 1, channel 1
and 2, or bridged output.
3. CH 2 Output Connector – This connector provides
the amplifier's Channel 2 output.
4. Air Outflow Vents – Warm air exits here.
5. Gain Switch – The Gain switch sets the gain for both
channels. Gain selections vary between models. Check
specifications for each model.
6. Mode Switch – This switch selects the amplifier's
operating mode (Bridge, Stereo, or Parallel Mono).
Note: KLR 5000 rear panel has different feature locations
(
7. 3-Pin Euroblock Input Connectors – These
connectors are used for balanced or unbalanced input
signals. For parallel mode or bridged mode, use INPUT 1
only.
8. Combination XLR, 1/4" TRS Input Connectors –
These connectors are used for balanced or unbalanced
input signals, and are wired in parallel with the Euroblock
connector.
9. Limiter Switch – This switch engages the limiter.
There is a separate limiter for each channel.
10. HPF Switch – This switch selects the input HiPass
filter to 30Hz, 50Hz, or Off.
All Rights Reserved
5.
Power Switch and LED – Switches the unit on
or off. The KLR 2000, KLR 3200, and KLR
4000 use a switch with a built in mains circuit-
breaker. The KLR 5000 uses a non-breaker
switch and an internal mains fuse instead.
Page - 5
Important Safety
Instructions – 2
Introduction - 3
The KLR Series - 4
Physical Description - 5
Front Panel
Rear Panel
Installation - 6
Troubleshooting - 10
Spec Table - 11
Warranty - 12
)
r
0611