BlueRange TRUCK680 Betriebshandbuch - Seite 4
Blättern Sie online oder laden Sie pdf Betriebshandbuch für Trucks BlueRange TRUCK680 herunter. BlueRange TRUCK680 8 Seiten. Hydraulic hand pallet truck
Seite drucken2. TO ATTACH DRAW-BAR TO PUMP UNIT (SUPPLIED UNASSEMBLED)
If your pallet truck has arrived unassembled, please follow the instructions to attach the Drawbar.
You will need following tools - a hammer, pliers, and spanner. Plus the following parts contained
in the enclosed bag:- Axle (A105), two cotter pins (A106) (Note one is pre fitted in the axle A105)
NOTE: The number of draw-bar and pump should be the same.
2.1 Insert the draw-bar onto the pump piston (A346), then
use a hammer to insert the axle with hole (A105) into the
hydraulic pump and draw-bar from the right to left. (See fig.
2 ).
2.2 Let control handle(A117) to the 'LOWER' position, then
pass the adjusting nut(A104), adjusting bolt(A103) and
chain(A102) through the hole of axle(A105) with your hand
(See fig. 3).
2.3 Press the draw-bar (A110, Al 10B) down, take away the
pin(#2) (See Fig. 1).
2.4 Let the control handle (A117) on 'RAISE' position, then
raise the lever plate (A315) with the pin (#2) and insert the
adjusting bolt(A103) into the front slot of lever plate (A315),
note to keep the adjusting nut (A104) on the under side of the
lever plate.
2.5 Use a hammer to tap another elastic pin (A106) into the
axle with hole (A105).
The draw-bar is now assembled to the pump.
Page 4