Ambient Technologies RCSTE Installations- und Betriebsanleitung - Seite 3

Blättern Sie online oder laden Sie pdf Installations- und Betriebsanleitung für Fernsteuerung Ambient Technologies RCSTE herunter. Ambient Technologies RCSTE 7 Seiten. Thermostatic on/off remote control – 120vac

Seite drucken
Installing Wire
This system comes with an 22 inch pre-assembled wire assembly. Insert the white terminal to the back of the
receiver. The terminal wire block can only be installed one way. Do not force the terminal plug onto the receiver.
Follow the homeowner's manual for connecting the two (2) 1/4" female spade terminals to the millivolt valve.
For applications longer than 22 inches, use 18 gauge wire, 105ºC rated, with as few splices as possible. Connect to
the two (2) 1/4" female spade wiring terminals. Wire can be no longer than 20 feet.
Optional 6 hour Shutdown
1. The receiver comes preset from the factory with a 6 hour shutdown from its last ON operation. This is done
to prevent the appliance from continuing to run if unattended.
2. You may disable this feature if you wish. To disable, change the receiver privacy (DIP) switch #1 ONLY to
the OFF position. Make sure the transmitter privacy (DIP) switches are set the same to the receiver. Follow
the instructions on how to set the privacy (DIP) switch setting.
3. By disabling this feature, your appliance may continue to run unattended.
Make sure that the wires do not contact the appliances any place other than at the terminals.
f i r e - p a r t s . c o m
Exposure to temperatures higher than 105C (250ºF) may cause the receiver to malfunction or
fire hazard.

Remote Transmitter

Installing Batteries:
The remote transmitter uses three (3) "AAA" batteries. To install batteries,
1.
Press down the battery door tab and lift up and remove the
battery door.
2.
Install the batteries as indicated on transmitter.
3.
Close the battery door by snapping in place.
4.
When three batteries are installed, the transmitter will initialize for 10
seconds and then is ready for use.
5.
The batteries should be replaced at least once every 6 months or when the
battery icon indicator flashes.
Setting Privacy (DIP) Switch on Receiver and Transmitter
The remote receiver and transmitter privacy (DIP) switches are preset at the factory. In the event of activation or
interference from other nearby transmissions, reset the code using the following procedure:
1.
Slide the code switches on the transmitter or receiver to your choice of ON or OFF position. Switches #1,
#2, #3 and #4 are preset to "ON" for both the transmitter and receiver.
2.
The switches on the transmitter and receiver must match in order for the system to work.
3.
To check, touch either the On or Off button on the transmitter and the receiver indicator light will blink. If
not repeat step 2.
4.
The system is now ready to operate. See optional 6 hour shutdown on receiver section.
50D0104 RCSTE Rel 0 Feb 10 2006
Battery
Door Tab
Page 3 of 7
Back of the Transmitter
Ambient Technologies
A Division Of Monessen Hearth Systems