Ambient Technologies WWTD Installations- und Betriebsanleitung - Seite 6

Blättern Sie online oder laden Sie pdf Installations- und Betriebsanleitung für Fernsteuerung Ambient Technologies WWTD herunter. Ambient Technologies WWTD 10 Seiten. Wireless wall thermostatic on/off remote control

Seite drucken
Reset Button:
1. The reset button can be used to reset the systems such as the clock setting. The reset button is located
behind the front flip door.
2. Using a paper clip, press the button and the system will reset and go into clock setting mode.
Setting Clock:
1. While in Manual mode, press SET to enter clock setting mode.
2. In clock setting mode, only clock is displayed. Press SET to select item (hour, minute or day). Selected
item is flashing. Press
Manual Mode:
1. Press the On button once to turn on the appliance. Press the OFF button to turn it off.
2. In manual mode, the transmitter will not turn the appliance off even if the room temperature is above the
target temperature.
Timer mode:
1. In manual or auto mode press TIME/CANCEL to enter Timer mode.
LCD will display only the timer time and room temperature.
2. In Timer mode, the preset time is 120 minutes (maximum).
4
3
3. Press
or
4. The transmitter will turn on the appliance when entering timer mode.
When the times run out, the transmitter will turn off the appliance and
return to Manual mode.
5. Timer count down can be cancelled by pressing:
a.
TIME/CANCEL which returns back to previous mode
b.
ON or OFF which returns to manual mode,
c.
AUTO which then goes to auto mode.
Auto mode:
6. Pressing either the ON or OFF button, it will change to Manual mode.
7. When AUTO and ON buttons are pressed simultaneously and held more than 3 seconds, it will enter
Auto-P (program) mode.
8. When TIMER/CANCEL button is pressed, it will change to timer mode.
Auto-P mode:
50D0077 Rev 1
4
3
or
to change. Selected item is flashing.
to select timer time in 10 minute increments.
1.
To enter auto mode, press AUTO in manual mode or timer mode.
2.
In auto mode, press SET (set temp will flash) and press
temperature. The default set temperature is 72º F. Press SET again to save and
exit.
3.
After entering auto mode, once the setting is completed, the transmitter
will automatically turn on the fireplace when the room temperature is below the
target temperature and turn off the appliance when the room temperature is above
the target temperature.
4.
There will be a slight delay in the response of the unit (on/off) to a
temperature. Temperature is monitored every 3 minutes.
5.
Flame icon will display when the transmitter is in "ON" position.
Page 6 of 10
4
3
or
to set
Ambient Technologies
A Division Of MHS