Ambient Technologies WWTD Installations- und Betriebsanleitung - Seite 7

Blättern Sie online oder laden Sie pdf Installations- und Betriebsanleitung für Fernsteuerung Ambient Technologies WWTD herunter. Ambient Technologies WWTD 10 Seiten. Wireless wall thermostatic on/off remote control

Seite drucken
Auto-P mode will allow the remote control systems to thermostatically control the appliance on weekdays (Monday
to Friday) and /or on weekends (Saturday and Sunday). The remote control systems cannot be programmed for
individual days. Each group of days (weekdays/weekends) can be programmed for up to two sets of time settings to
cycle.
1. Press AUTO and ON buttons simultaneously and hold for 3 seconds to enter auto programming mode.
2.
Press AUTO to start programming the remote. The AUTO button becomes the set button in the Auto P
mode.
3. When entering Auto-P mode, there are no default values and a blank display will be seen as illustrated
below.
4
3
4. Press
or
5. Press AUTO to save hour and move to minutes.
4
3
6. Press
or
7. Press AUTO to save minutes and move to temperature.
4
3
8. Press
or
9. Press AUTO to save temperature and move to the 2'nd, 3'rd, & 4
10. Repeat the program process for each of the settings. Up to 4 settings are available for each day, but you
may set any number up to 4 settings.
11. This completes the programming for Monday (S) to Friday (F) setting. Repeat the process for the Saturday
(S) to Sunday (S) setting.
12. There will be a slight delay in the response of the unit (on/off) to a temperature change.Temperature is
monitored every 3 minutes.
13. When ON or OFF buttons are
pressed, it will change to Manual
mode.
14. When AUTO button is pressed, it
will change to Auto mode.
15. When TIMER/CANCEL button is
pressed, it will change timer mode.
Low-battery detection:
1. Battery voltage is checked once a minute. When the battery voltage
drops to a certain level, the low-battery warning will come on, and the
transmitter will turn off the appliance. The transmitter will not
function anymore until fresh batteries are installed.
2. When the batteries are low, the LCD shows a low battery indicator. The
low battery warning will be displayed in any mode.
3. The transmitter will not operate with low batteries. Change the battery
before the battery is too weak for normal operation. TURN THE UNIT
OFF BEFORE REPLACING BATTERIES.
Child-proof protection:
1. Press and hold ON and OFF buttons simultaneously for 3 seconds to enter child-proof mode.
50D0077 Rev 1
buttons to set hour for 1'st setting.
buttons to set minutes for 1'st setting.
buttons to set temperature for 1'st setting.
Blank LCD display
Page 7 of 10
th
settings of the day.
Default LCD values
Ambient Technologies
A Division Of MHS