ACR Electronics RCL-75 Handbuch zur Produktunterstützung - Seite 10
Blättern Sie online oder laden Sie pdf Handbuch zur Produktunterstützung für Flutlicht ACR Electronics RCL-75 herunter. ACR Electronics RCL-75 20 Seiten. Remote control searchlight system
Auch für ACR Electronics RCL-75: Handbuch zur Produktunterstützung (15 seiten), Handbuch zur Produktunterstützung (20 seiten)
Seite drucken
Remove the deck mounting plate from the light base (4 Allen bolts).
Save the bolts and washers. Locate the mounting plate on the spot that
you want your light. Rotate the plate so that the arrows are pointing
forward and the length of the arrow is aligned parallel to the keel.
Mark the 4 mounting holes, starting with the hole marked "Front" on the
mounting plate. Mounting holes are in 90° increments. Drill 4 mounting
holes (1/4") and a centered cable clearance hole (3/4"). Put the
mounting gasket on the deck mount (or shaped plate, if used). Use
caulk or bedding compound to seal bolt and wire holes before deck
mount is attached to deck. The plates are keyed to each other and to
the light: Be sure the arrows are pointing in the correct direction. The
light will rotate 180° either way from the arrows.
Figure 7
Y1-03-0158G
Figure 6-Shapeable plate
(purchased separately)
Use
marine
stainless steel bolts, nuts, and
lock washers to fasten the
plate(s)
to
surface. Install and connect the
control cable and (+) Red and
(-) Black power leads. Seal
hole if desired. Leave at least 8
inches (20.32 cm) of wire
coiled in the base of light to
allow for servicing (see Figure
7).
grade
316
the
mounting
9