ACR Electronics RCL-75 Руководство по поддержке продукта - Страница 10

Просмотреть онлайн или скачать pdf Руководство по поддержке продукта для Заливающий свет ACR Electronics RCL-75. ACR Electronics RCL-75 20 страниц. Remote control searchlight system
Также для ACR Electronics RCL-75: Руководство по поддержке продукта (15 страниц), Руководство по поддержке продукта (20 страниц)

Remove the deck mounting plate from the light base (4 Allen bolts).

Save the bolts and washers. Locate the mounting plate on the spot that

you want your light. Rotate the plate so that the arrows are pointing

forward and the length of the arrow is aligned parallel to the keel.

Mark the 4 mounting holes, starting with the hole marked "Front" on the

mounting plate. Mounting holes are in 90° increments. Drill 4 mounting

holes (1/4") and a centered cable clearance hole (3/4"). Put the

mounting gasket on the deck mount (or shaped plate, if used). Use

caulk or bedding compound to seal bolt and wire holes before deck

mount is attached to deck. The plates are keyed to each other and to

the light: Be sure the arrows are pointing in the correct direction. The

light will rotate 180° either way from the arrows.

Figure 7

Y1-03-0158G

Figure 6-Shapeable plate

(purchased separately)

Use

marine

stainless steel bolts, nuts, and

lock washers to fasten the

plate(s)

surface. Install and connect the

control cable and (+) Red and

(-) Black power leads. Seal

hole if desired. Leave at least 8

inches (20.32 cm) of wire

coiled in the base of light to

allow for servicing (see Figure

7).

grade

316

the

mounting