ACR Electronics RCL-75 Руководство по поддержке продукта - Страница 7

Просмотреть онлайн или скачать pdf Руководство по поддержке продукта для Заливающий свет ACR Electronics RCL-75. ACR Electronics RCL-75 20 страниц. Remote control searchlight system
Также для ACR Electronics RCL-75: Руководство по поддержке продукта (15 страниц), Руководство по поддержке продукта (20 страниц)

bulkhead, use a cable outlet (available at marine hardware stores). Wire

should be supported where necessary by the use of cable straps.

The location selected must be sufficiently rigid to support the weight of

the total installation. Also consider surrounding hazards such as

equipment movement, hatches being opened, accidental covering,

personnel traffic, etc.

Depending on the location selected, your light will need 1/4" diameter

stainless steel bolts, nuts, and washers. If the mounting area is robust

enough, pan-head lag screws may be used. If the surface area can be

reached from the underside, bolting with lock nuts and washers should

be used.

Figure 2

Figure 3

When mounting, be sure that the unit is able to rotate 360° without

hitting any obstructions. Refer to wiring section for additional

information.

SECTION 3 - INSTALLATION

Wiring

The RCL-75 has two wiring requirements:

1.) Connect the remote control Point Pad™ to the light

2.) Connect the light to 12-volt power with 15 amp rated wiring. The

light works best with 13.5 volts.

Y1-03-0158G