Floe VSD 6000 Manual de instrucciones de montaje - Página 6

Navegue en línea o descargue pdf Manual de instrucciones de montaje para Equipamiento náutico Floe VSD 6000. Floe VSD 6000 12 páginas. Full length pontoon & tri-toon bunks large lifts
También para Floe VSD 6000: Manual de instrucciones de montaje (12 páginas), Manual de instrucciones de montaje (8 páginas), Manual de instrucciones de montaje (16 páginas)

ST EP 2

Frame beams are fastened to the corner posts using

the pre-attached lower clamps. See clamp layout top

view in Fig. 2C. Insert frame beam spacers into ends

of all four frame beams before assembly as shown in

Fig. 2D.

For ease of assembly, attach the 118" front and rear

frame beams first. Lay the rear corner posts down and

fasten to the frame beam using (4) 1/ 2" x 4" bolts, (8)

flat washers and (4) nylock nuts. The front frame beam

is attached the same as the rear but use (2) 1/ 2" x 5"

bolts on the bottom holes. Do not tighten the nuts on

the 5" bolts at this time. See Fig 2B and 2C.

The 108" side frame beams are attached using

(4) 1/ 2" x 4" bolts, (8) flat washers and (4) aluminum

nylock nuts on each beam. See fig. 2C.

To help keep the frame square while assembling,

gradually tighten each bolt a little at a time, and

alternate between each side of the clamp. Torque

all clamp bolts to 100 ft/ lbs.

Fig. 2A

rear frame beam

front frame beam

Fig. 2C

Clamp Layout

Lifting corner

1/ 2 x 4" bolt, nut and

washers installed from inside

of lift. Torque to 100 ft/ lbs.

1/ 2 x 5" bolt, nut & washers

installed from outside of lift.

Do not tighten at this time

1/ 2 x 4" bolt, nut and

washers. Torque to 100 ft/ lbs.

SHEET 6 OF 12

Fig. 2D

Spacer Placement

Fig. 2B

Fig. 2A

Fig. 2B

Fig. 2D

1/ 2 x 5" bolt