Floe VSD 8000 Manual de instrucciones de montaje - Página 8

Navegue en línea o descargue pdf Manual de instrucciones de montaje para Sistemas de elevación Floe VSD 8000. Floe VSD 8000 12 páginas. Full length pontoon & tri-toon bunks large lifts
También para Floe VSD 8000: Manual de instrucciones de montaje (8 páginas), Manual de instrucciones de montaje (8 páginas), Manual de instrucciones de montaje (16 páginas)

Imprimir página
Floe VSD 8000 Manual de instrucciones de montaje
FOLLOW THESE GUIDELINES FOR USING AND LOCATING THE PONTOON BUNKS (FIGURE 2.5A & 2.5B).
-THE WIDTH OF THE BUNKS SHOULD BE 1-2 INCHES LESS THAN THE DISTANCE BETWEEN THE
PONTOONS.
-TO SET BUNK HEIGHT, MEASURE FROM THE BOTTOM OF THE PONTOON DECK TO THE BOTTOM OF
THE PONTOON, THEN ADD 1" TO THAT MEASUREMENT.
-THE REAR OF A 21 FOOT PONTOON BOAT SHOULD OVERHANG PAST THE LIFT BY 3 FEET. FOR EVERY
ADDITIONAL FOOT IN LENGTH OF THE BOAT, IT SHOULD OVERHANG BY AN ADDITIONAL 6 INCHES
BEYOND THE REAR OF THE LIFT.
THESE ARE THE GENERAL GUIDELINES THAT CAN BE ADJUSTED FOR AN INDIVIDUAL'S
CIRCUMSTANCES.
ONCE FINAL POSITION IS SET, TORQUE 3/8" NUTS ON CLAMPS TO 35 FT-LBS (FIGURE 2.6).
FIGURE
2.5A
UPRIGHTS MAY HAVE TO BE CUT TO
ALLOW FULL TRAVEL OF CRADLE ONCE
FINAL PLACEMENT IS ESTABLISHED.
NOTE:
SHEET 8 OF 12