Floe VSD 8000 Инструкция по сборке - Страница 8

Просмотреть онлайн или скачать pdf Инструкция по сборке для Подъемные системы Floe VSD 8000. Floe VSD 8000 12 страниц. Full length pontoon & tri-toon bunks large lifts
Также для Floe VSD 8000: Инструкция по сборке Руководство (8 страниц), Инструкция по сборке Руководство (8 страниц), Инструкция по сборке Руководство (16 страниц)

FOLLOW THESE GUIDELINES FOR USING AND LOCATING THE PONTOON BUNKS (FIGURE 2.5A & 2.5B).

-THE WIDTH OF THE BUNKS SHOULD BE 1-2 INCHES LESS THAN THE DISTANCE BETWEEN THE

PONTOONS.

-TO SET BUNK HEIGHT, MEASURE FROM THE BOTTOM OF THE PONTOON DECK TO THE BOTTOM OF

THE PONTOON, THEN ADD 1" TO THAT MEASUREMENT.

-THE REAR OF A 21 FOOT PONTOON BOAT SHOULD OVERHANG PAST THE LIFT BY 3 FEET. FOR EVERY

ADDITIONAL FOOT IN LENGTH OF THE BOAT, IT SHOULD OVERHANG BY AN ADDITIONAL 6 INCHES

BEYOND THE REAR OF THE LIFT.

THESE ARE THE GENERAL GUIDELINES THAT CAN BE ADJUSTED FOR AN INDIVIDUAL'S

CIRCUMSTANCES.

ONCE FINAL POSITION IS SET, TORQUE 3/8" NUTS ON CLAMPS TO 35 FT-LBS (FIGURE 2.6).

FIGURE

2.5A

UPRIGHTS MAY HAVE TO BE CUT TO

ALLOW FULL TRAVEL OF CRADLE ONCE

FINAL PLACEMENT IS ESTABLISHED.

NOTE:

SHEET 8 OF 12