Floe VSD 6000 Manual de instrucciones de montaje - Página 11

Navegue en línea o descargue pdf Manual de instrucciones de montaje para Tienda Floe VSD 6000. Floe VSD 6000 12 páginas. Full length pontoon & tri-toon bunks large lifts
También para Floe VSD 6000: Manual de instrucciones de montaje (12 páginas), Manual de instrucciones de montaje (8 páginas), Manual de instrucciones de montaje (16 páginas)

ST EP 7

The drive train can now be attached to the

clamp on the lift. Note that the rigid

coupler on the ball screw and the drive

drain mate together. With the drive train

being held in place, attach it to the lift

clamp using 3/ 8" x 1" bolts, nylock nuts

and flat washers as shown if Fig 7A.

3/ 8" nylock

nut (x4)

3/ 8" flat washer (x4)

3/ 8" x 1 3/ 4" bolt (x4)

Fig. 7A

Drive

Train

Box

Down

Fig. 7B

Fig. 7A

Plug the wired remote into the

socket on the control panel of the

drive train. Use the supplied

Velcro to run the wire to the

desired location of the remote.

Plug the limit switch wire into the

control panel marked "Up Limit".

Wired Remote

The limit switch wire is located on

the channel on the bottom side of

the ball screw tube.

SHEET 11 OF 12

Optiona l Wireless Remote

If you purchased the optional wireless

remote, the receiver box must be installed.

Plug the wire into the "radio remote" plug on

the control panel. Using the supplied

adhesive Velcro, attach the box to the corner

post or canopy frame with the antenna

facing away from the metal framework.