Floe VSD 6000 조립 지침 매뉴얼 - 페이지 11
{카테고리_이름} Floe VSD 6000에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Floe VSD 6000 12 페이지. Full length pontoon & tri-toon bunks large lifts
Floe VSD 6000에 대해서도 마찬가지입니다: 조립 설명서 (12 페이지), 조립 지침 매뉴얼 (8 페이지), 조립 지침 매뉴얼 (16 페이지)
페이지 인쇄
ST EP 7
The drive train can now be attached to the
clamp on the lift. Note that the rigid
coupler on the ball screw and the drive
drain mate together. With the drive train
being held in place, attach it to the lift
clamp using 3/ 8" x 1" bolts, nylock nuts
and flat washers as shown if Fig 7A.
3/ 8" nylock
nut (x4)
3/ 8" flat washer (x4)
3/ 8" x 1 3/ 4" bolt (x4)
Fig. 7A
Drive
Train
Box
Up
Down
Fig. 7B
Fig. 7A
Plug the wired remote into the
socket on the control panel of the
drive train. Use the supplied
Velcro to run the wire to the
desired location of the remote.
Plug the limit switch wire into the
control panel marked "Up Limit".
Wired Remote
The limit switch wire is located on
the channel on the bottom side of
the ball screw tube.
SHEET 11 OF 12
Optiona l Wireless Remote
If you purchased the optional wireless
remote, the receiver box must be installed.
Plug the wire into the "radio remote" plug on
the control panel. Using the supplied
adhesive Velcro, attach the box to the corner
post or canopy frame with the antenna
facing away from the metal framework.