Coalesse Lagunitas Instrucciones de instalación - Página 3
Navegue en línea o descargue pdf Instrucciones de instalación para Mobiliario interior Coalesse Lagunitas. Coalesse Lagunitas 4 páginas. Corner screen replacement
También para Coalesse Lagunitas: Manual (3 páginas)
Imprimir páginaMESH SCREEN GANGING CLIP INSTALLATION:
WARNING: Ganging units using the screen ganging clip will
require creating a hole in the upholstery. This hole is only visible
if the units are separated.
NOTE: The screen ganging clip can only be used if the adjoining
screens are the same height.
1.
Determine assembled configuration of your screens to confirm
where screen ganging clips must be applied. Locate the hole in the
frame on the side of the screen (approximately 4 inches down from
the top) by pressing your finger along the seam (you will feel the
indentation). Place a mark on the fabric mesh at the hole location.
Repeat at all points where ganging clips must be used.
2.
Using a hot knife, carefully melt the mesh approximately1/2" long.
A small hole will now be visible in the knit /mesh material. Repeat at
all points where ganging clips will be used.
3.
Install screen ganging clips (with the overlapping joint on top)
until a 'click' is heard. Pull on the clip to ensure the clip is engaged in
the screen frame and can't be pulled out from the screen.
1
4 "
2
1 / 2
"
OVERLAPPING
3
JOINT
SCREEN
GANGING CLIP
Page 3 of 4
69925 Rev B