Coalesse Lagunitas 설치 지침 - 페이지 3

{카테고리_이름} Coalesse Lagunitas에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Coalesse Lagunitas 4 페이지. Corner screen replacement
Coalesse Lagunitas에 대해서도 마찬가지입니다: 매뉴얼 (3 페이지)

페이지 인쇄

MESH SCREEN GANGING CLIP INSTALLATION:

WARNING: Ganging units using the screen ganging clip will

require creating a hole in the upholstery. This hole is only visible

if the units are separated.

NOTE: The screen ganging clip can only be used if the adjoining

screens are the same height.

Determine assembled configuration of your screens to confirm

where screen ganging clips must be applied. Locate the hole in the

frame on the side of the screen (approximately 4 inches down from

the top) by pressing your finger along the seam (you will feel the

indentation). Place a mark on the fabric mesh at the hole location.

Repeat at all points where ganging clips must be used.

Using a hot knife, carefully melt the mesh approximately1/2" long.

A small hole will now be visible in the knit /mesh material. Repeat at

all points where ganging clips will be used.

Install screen ganging clips (with the overlapping joint on top)

until a 'click' is heard. Pull on the clip to ensure the clip is engaged in

the screen frame and can't be pulled out from the screen.

4 "

1 / 2

OVERLAPPING

JOINT

SCREEN

GANGING CLIP

Page 3 of 4

69925 Rev B