12Volt DirectStart CS423 Manual de instalación - Página 4

Navegue en línea o descargue pdf Manual de instalación para Arranque a distancia 12Volt DirectStart CS423. 12Volt DirectStart CS423 13 páginas. Remote car starter 2/ 3 zone intrusion alarm options

Imprimir página

TRANSMITTER

BUTTON #1

"LOCK" Icon

Button #I (Lock Icon) is used to LOCK (Optional) electric door locks and/or ARM engine interrupt

circuit and/or intrusion alarm. A LOCK/ARM signal is sent each time the Button #I is pressed.

Parking lights flash once to confirm. (Horn chirp is Optional).

BUTTON #2

Button #II is used to Remote Start your vehicle.

BUTTON #3

"UNLOCK " Icon

Button # III is used to UNLOCK (Optional) electric door locks and/or DISARM engine interrupt

circuit and or intrusion alarm options. Parking Lights flash twice to confirm . (Horn chirp is Optional)

NOTES:

* You cannot arm the system if the IGNITION KEY is in the ON position.

** Engine Interrupt Circuit can be programmed for PASSIVE or ACTIVE Arming. Bank I, Function 2

***Door Locks can be programmed for PASSIVE or ACTIVE ARMING. Bank I , Function 1.

*Note Alarm Settings must be enabled (Bank I, Function 8) in order to activate the Intrusion Alarm

features to be programmed for ACTIVE or PASSIVE ARMING (Bank I, Function 1)

TRANSMITTER

TRANSMITTER PROGRAMMING

TRANSMITTER

1. Open the hood. (J2-PIN#14 Violet hood switch wire must see ground )

2. Toggle the Ignition Key ON and OFF 8 times...(Start and Finish in the OFF position)

Parklights will come on solid to indicate system is in Transmittter learning mode.

3. Press 'LOCK' Button to program (learn) the transmitter. System will confirm transmitter is

programmed correctly by flashing the parking lights (1) one time if Tx is new to the system

or (2) twice if Tx has previously been learned (programmed).

4. Transmitter is now programmed to operate the system. At this point you have the option of

A) Exiting programming mode by turning the IGNITION KEY to the ON position.

B) Proceeding directly into Function programming by pressing (LOCK) Button I to

select Bank I Function Settings or (START) Button II to select Bank II Function

Settings.

*NOTE: ONLY ONE TRANSMITTER CAN BE PROGRAMMED AT A TIME, THE TRANSMITTER

PROGRAMMING SEQUENCE MUST BE REPEATED FOR EACH NEW TRANSMITTER.

**NOTE: A MAXIMUM OF 6 TRANSMITTERS CAN BE LEARNED PER SYSTEM

System Programming Automatically follows after each transmitter is programmed unless the ignition is turned

to the ON position to exit programming mode altogether.

CS400 DIRECTSTART

REMOTE CAR STARTER + ALARM

"START" Icon

CS400 VERSION 412

(Description & Operation)

PROGRAMMING