12Volt DirectStart CS423 Manual de instalación - Página 6

Navegue en línea o descargue pdf Manual de instalación para Arranque a distancia 12Volt DirectStart CS423. 12Volt DirectStart CS423 13 páginas. Remote car starter 2/ 3 zone intrusion alarm options

Imprimir página
BANK 1 1 1 1 PROGRAMMING
BANK
BANK
BANK
FUNCTIONS
FUNCTIONS
FUNCTIONS
FUNCTIONS
1 - Door lock
Note Option #3 will (A) erase all transmitters. (B) Reset factory defaults (C) Exit programming & enter armed state
2 - Interrupt Circuit
J2-PIN#6 (BROWN)
3 - Lock/Unlock Timing
4 - Prog. Output #1
J2 –PIN#4 (GREY)
5 - Ignition Lock
6 - Cold start
7- Run time
8 - *Alarm Setting
9 - Ext. trigger
J2-PIN#3(Wht/ Purple)
*Note- This input acts as an alarm input trigger only on automatic transmission vehicles. In Manual
transmission mode this input is used as the safety hand brake connection and overrides all other
options.
*Alarm Settings must be enabled inorder to activate intrusion alarm features. Function 8 above.
**To enable Passive Arming Intrusion Alarm features you must change doorlock option to passive
locking (Bank I, Function 1, OPTION 2).
CS400 DIRECTSTART
REMOTE CAR STARTER + ALARM
PROGRAMMING
PROGRAMMING
PROGRAMMING
OPTIONS
OPTIONS
OPTIONS
OPTIONS
*
Option 1 :: Active door lock
Button 2 : Passive door lock (Doors/Alarm lock w/ Interrupt Circuit)
Button 3 : Erase all learned code and reset to original default
*
Option 1 : Active Arming
Option 2 : Passive arming (arm after 30 sec. Ign. off
Option 3: Passive arming (arm after 60 sec. Ign. off)
*
Option 1 : Lock 1 sec. / Unlock 1 sec.
Option 2 : Lock 1 sec. / Unlock 2 pulses of 0.5 sec.
Option 3 : Lock 4 sec. / Unlock 4 sec
*
Option 1 : Button 3 (#) - 1 sec. output only if ign. off (trunk)
Option 2 : Button 3 (#) - 1 sec. output (garage door)
*
Option 1 : Ignition Lock Off
Option 2 : Ignition Lock and Unlock
Option 3 : Ignition Lock only
*
Option 1 : Cold start mode enable with 2 hours intervals
Option 2 : Cold start mode enable with 4 hours intervals
Option 3 : Cold start disable
*
Option 1 : 15 minutes
Option 2 : 20 minutes
Option 3 : 10 minutes
*
Option 1 : Alarm & Ignition Tamper OFF
Option 2 : Alarm & Ignition Tamper ON
*
Option 1 : External Start trigger enable. No Alarm zone3.
Option 2 : Ext. trigger input used as alarm trigger zone 3
CS400 VERSION 412
.
.
6