Canon AE-1 Manual de procedimientos de instalación - Página 38
Navegue en línea o descargue pdf Manual de procedimientos de instalación para Cámara digital Canon AE-1. Canon AE-1 48 páginas.
También para Canon AE-1: Primeros pasos (2 páginas), Manual de instrucciones (22 páginas), Manual (42 páginas), Manual (12 páginas), Manual de instrucciones (22 páginas)
Imprimir página
5) Remove the stepped screw [l] used to join the fin-
isher to the host machine.
6) Remove the screw [I], and detach the small cover
[2] at the upper rear of the finisher; then, remove the
stepped screw [3], and disconnect the finisher from
the host machine at the rear. Then cut off the face
cover [4] using a nipper.
8) In the case of a Saddle Finisher-AE2, remove the
three screws [I], and detach the lower front exten-
sion cover [2] and the front foot cover [3]. Remove
the screw [4], and detach the rear foot cover [5]. Re-
move the screw [6], and detach the caster cover [7].
9) Remove the four screws [ l ]
,
and detach the fixing
plate (front) [2] and the other fixing plate (rear) 131.
A
If the fixing plate [2] cannot be removed because
the blanking part on the host machine's left cover is
small, remove the following parts:
Host machine's front cover (one blanking rubber
and two screws)
Host machine's left cover (four screws)
Next, remove the fixing plate [2].
Attach the removed cover in place after completion
of step 10.
7) In the case of a Saddle Finisher-AE2, close the front
cover. In the case of a Finisher-AEl, mount the
front cover using three screws.