Da-Lite Contour Electrol Libro de instrucciones - Página 6

Navegue en línea o descargue pdf Libro de instrucciones para Pantalla de proyección Da-Lite Contour Electrol. Da-Lite Contour Electrol 8 páginas. Installer friendly features
También para Da-Lite Contour Electrol: Libro de instrucciones (13 páginas), Libro de instrucciones (9 páginas), Manual del instalador (2 páginas), Libro de instrucciones (4 páginas), Libro de instrucciones (8 páginas)

Imprimir página
Da-Lite Contour Electrol Libro de instrucciones
SCREEN ADJUSTMENT
INSTRUCTIONS FOR 240 VOLT SCREENS
SETTING THE DOWN LIMIT POSITION
TO REDUCE SCREEN DROP:
Turn the
limit switch screw counterclockwise to decrease the amount of screen drop. Run the screen down to
test the stop position. If the screen drops too far, raise the screen about one foot and adjust the limit switch again.
Repeat until the desired position is set.
TO INCREASE SCREEN DROP:
Turn the
limit switch screw clockwise to increase the amount of screen drop. Run the screen down to test the
stop position. If the screen does not drop enough, raise the screen about one foot and adjust the limit switch again.
Repeat until the desired position is set. Do not adjust for more drop than what was ordered. At least 1-1/2 wraps of
fabric must remain on the roller.
SETTING THE UP LIMIT POSITION
▲
CAUTION: Do not allow the slat bar to become wedged between the roller and case. This could damage the fabric and motor.
!
Always check that the slat is free to move inside the case.
SCREEN TRAVELS INTO CASE TOO FAR:
Turn the
limit switch screw clockwise to decrease the amount of travel. Run the screen up to test the stop
position. If the screen does not stop properly, lower the screen about one foot and turn the limit switvh again.
Repeat until the desired position is set.
SCREEN DOES NOT TRAVEL FAR ENOUGH INTO CASE:
Turn the
limit switch screw counterclockwise to increase the amount of up travel. Run the screen up to test the
stop position. If more travel is desired, lower the screen about one foot and adjust the limit switch again. Repeat
until the desired position is set.
5