Da-Lite Contour Electrol Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Ekran projekcyjny Da-Lite Contour Electrol. Da-Lite Contour Electrol 8 stron. Installer friendly features
Również dla Da-Lite Contour Electrol: Instrukcja obsługi (13 strony), Instrukcja obsługi (9 strony), Podręcznik instalatora (2 strony), Instrukcja obsługi (4 strony), Instrukcja obsługi (8 strony)

SCREEN ADJUSTMENT

INSTRUCTIONS FOR 240 VOLT SCREENS

SETTING THE DOWN LIMIT POSITION

TO REDUCE SCREEN DROP:

Turn the

limit switch screw counterclockwise to decrease the amount of screen drop. Run the screen down to

test the stop position. If the screen drops too far, raise the screen about one foot and adjust the limit switch again.

Repeat until the desired position is set.

TO INCREASE SCREEN DROP:

Turn the

limit switch screw clockwise to increase the amount of screen drop. Run the screen down to test the

stop position. If the screen does not drop enough, raise the screen about one foot and adjust the limit switch again.

Repeat until the desired position is set. Do not adjust for more drop than what was ordered. At least 1-1/2 wraps of

fabric must remain on the roller.

SETTING THE UP LIMIT POSITION

▲

CAUTION: Do not allow the slat bar to become wedged between the roller and case. This could damage the fabric and motor.

Always check that the slat is free to move inside the case.

SCREEN TRAVELS INTO CASE TOO FAR:

Turn the

limit switch screw clockwise to decrease the amount of travel. Run the screen up to test the stop

position. If the screen does not stop properly, lower the screen about one foot and turn the limit switvh again.

Repeat until the desired position is set.

SCREEN DOES NOT TRAVEL FAR ENOUGH INTO CASE:

Turn the

limit switch screw counterclockwise to increase the amount of up travel. Run the screen up to test the

stop position. If more travel is desired, lower the screen about one foot and adjust the limit switch again. Repeat

until the desired position is set.