Da-Lite Wireline Advantage Manual de instrucciones - Página 2
Navegue en línea o descargue pdf Manual de instrucciones para Pantalla de proyección Da-Lite Wireline Advantage. Da-Lite Wireline Advantage 8 páginas.
Imprimir página
Important Safety Instructions
When using your video equipment, basic safety precautions
should always be followed, including the following:
1.
Read and understand all instructions before using.
2.
Position the cord so it will not be tripped over, pulled or contact
hot surfaces.
3.
If an extension cord is necessary, a cord with a current rating at
least equal to that of the appliance should be used. Cords rated
for less amperage than the appliance may overheat.
4.
To reduce the risk of electric shock, do not disassemble this
appliance. Contact an authorized service dealer when repair
work is required. Incorrect reassembly can cause electric shock
when the appliance is used subsequently.
5.
The use of an accesory attachement not recommended by the
manufacturer may cause a risk of fire, electric shock, or injury to
persons.
6.
Do not allow children to play with fixed controls. Keep remote
controls away from children.
7.
Frequently examine the installation for imbalance and signs of
wear or damage to cables. Do not use if repair or adjustment is
necessary.
Save These Instructions
Tools Required for Installation
1/4" and 3/4"
Open Wrench or
Socket Driver
Pre-Installation
1.
Carefully unpack case from shipping crate.
2.
Set aside the Installation Kit. Items inside will be used during
installation.
3.
Make sure to recheck measurement of case for proper
installation clearance.
4.
Remove any protective foam from case.
5.
If necessary. adjust hanger brackets with a 3/4" open wrench
or socket driver.
2
1/8" Hex Key
(included)
Case Installation
1.
The case provides multiple attachment points for bolts,
cables, or threaded rod. Page 4 shows threaded rod
installed. The variable position-mounting bracket may be
located anywhere along the length of the case. It is
recommended to keep the brackets spaced evenly enough
to distribute the weight of the screen. One mounting bracket
is required for every 4' of case length.
2.
Tighten bolts until trim flange is flush with ceiling.
NOTE: For proper operation, screen assembly must be level
after installation.
3.
Remove 2 screws to open junction box. Install electrical
connections that apply to your unit. Make sure to review the
wiring diagram for proper hook up. Replace junction box
cover and secure with 2 screws.
NOTE: Please Note: Motor Operator Projection Screen Model
WAD must be installed in accordance with the requirements
of the Local Building Codes, the Canadian Electrical Code
(CEC), CAN/CSA C22.1 and the National Electric Code (NEC),
NFPA 70. An appropriate disconnect device shall be
provided as part of the building installation.
4.
Remove the silver shipping brackets that attach the slat to
the screen case. Use the supplied 1/8" hex key to remove the
set screws and a 1/4" socket to remove the screws from the
slat bar.
5.
Test installation by running screen up and down a few times.
Be prepared to stop screen should any objects obstruct the
movement of the screen. To prevent damage to the motor,
the standard duty cycle is 2 minute 30 seconds on and 50
minutes off.
6.
The screen comes set standard with 18" of wire drop out of
the case.