Da-Lite Wireline Advantage Manual de instrucciones - Página 4
Navegue en línea o descargue pdf Manual de instrucciones para Pantalla de proyección Da-Lite Wireline Advantage. Da-Lite Wireline Advantage 8 páginas.
Imprimir página
Screen Adjustment
Surface travel is set to stop automatically with 18" of wire travel out of the case. Use the supplied radio frequency remote control to
make adjustments to the amount of travel.
More Screen Drop
1.
Run screen in down direction until it reaches lower limit and
stops.
2.
Press and hold both UP and DOWN arrows simultaneously until
screen jogs.
3.
Run screen to new desired lower limit position by pressing
DOWN arrow on remote
Note: Motor will run in momentary contact mode while in this
procedure. If you go to far down you can press up and move
to the next step.
4.
Press and MY (STOP) button until the screen jogs to confirm
new limit.
CAUTION: Do not adjust for more than 29' of cable drop.
ATTENTION! Ne pas régler plus de 884 centimètres de chute
de câble
Less Screen Drop
1.
Run screen in down direction until it reaches lower limit and
stops.
2.
Press and hold both UP and DOWN arrows simultaneously until
screen jogs.
3.
Run screen to new desired lower limit position by pressing UP
arrow on remote.
Note: Motor will run in momentary contact mode while in this
procedure. If you go to far down you can press down and
move to the next step.
4.
Press and MY (STOP) button until the screen jogs to confirm
new limit.
Note: The entire screen must be unrolled from the large roller
for proper tensioning.
4
Figure 1