Da-Lite Wireline Advantage Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Ekran projekcyjny Da-Lite Wireline Advantage. Da-Lite Wireline Advantage 8 stron.

Screen Adjustment

Surface travel is set to stop automatically with 18" of wire travel out of the case. Use the supplied radio frequency remote control to

make adjustments to the amount of travel.

More Screen Drop

Run screen in down direction until it reaches lower limit and

stops.

Press and hold both UP and DOWN arrows simultaneously until

screen jogs.

Run screen to new desired lower limit position by pressing

DOWN arrow on remote

Note: Motor will run in momentary contact mode while in this

procedure. If you go to far down you can press up and move

to the next step.

Press and MY (STOP) button until the screen jogs to confirm

new limit.

CAUTION: Do not adjust for more than 29' of cable drop.

ATTENTION! Ne pas régler plus de 884 centimètres de chute

de câble

Less Screen Drop

Run screen in down direction until it reaches lower limit and

stops.

Press and hold both UP and DOWN arrows simultaneously until

screen jogs.

Run screen to new desired lower limit position by pressing UP

arrow on remote.

Note: Motor will run in momentary contact mode while in this

procedure. If you go to far down you can press down and

move to the next step.

Press and MY (STOP) button until the screen jogs to confirm

new limit.

Note: The entire screen must be unrolled from the large roller

for proper tensioning.

Figure 1