Donovan Hammer II Manual del usuario - Página 12

Navegue en línea o descargue pdf Manual del usuario para Equipamiento industrial Donovan Hammer II. Donovan Hammer II 20 páginas. Arm system for belly dumps, end dumps, dump bodies & pups

Tarp Tube Assembly & Tarp Installation
Item Part #
Description
1.
1809408 Upper Arm
2.
1809553 Upper Arm - 30° - Driver Side
3.
1809554 Upper Arm - 30° - Passenger Side
4.
1809409 Rear Crosspiece
5.
1808819 Rubber Bumper Assembly - 6"
B.
1800609 Shoulder Bolt - 1/4" x 1-1/4"
K.
1800610 Tee Nut - 1/4" x 7/16"
STEP 1: Center rear crosspiece between upper arms.
NOTE: Deburr inside
of tarp tube or outside
of elbow if elbow will
not easily slide into
tarp tube.
STEP 2: Lay assembled tarp tube on flat surface with ends of
tube laying flat and facing same direction. Drill two
5/16" holes on tarp tube side of joint. Fasten with
shoulder bolt
B
assembled
tarp tube
9
6"
and tee nut
.
K
5/16"
drill
hole
B
K
face both ends of tarp
tube in same direction
1
2
K
STEP3:
Slide rubber bumpers onto upper arm. Push bumpers
as far into bends as possible.
upper
arm
rubber
bumper
P/N 1809533 Rev. B
4
B
5
1
rear
crosspiece
push bumbers
into bends
STEP 4: Feed rear crosspiece
through pocket on rear end
of tarp. Reassemble tarp
tarp pocket
tube and elbow. Fasten
with shoulder bolt
tee nut
B
K
rear
crosspiece
3
rubber
bumper
upper
arm
and
B
.
K
rubber
bumper
upper
arm