Donovan Hammer II Kullanıcı El Kitabı - Sayfa 12
Endüstriyel Ekipmanlar Donovan Hammer II için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Donovan Hammer II 20 sayfaları. Arm system for belly dumps, end dumps, dump bodies & pups
Sayfayı YazdırTarp Tube Assembly & Tarp Installation
Item Part #
Description
1.
1809408 Upper Arm
2.
1809553 Upper Arm - 30° - Driver Side
3.
1809554 Upper Arm - 30° - Passenger Side
4.
1809409 Rear Crosspiece
5.
1808819 Rubber Bumper Assembly - 6"
B.
1800609 Shoulder Bolt - 1/4" x 1-1/4"
K.
1800610 Tee Nut - 1/4" x 7/16"
STEP 1: Center rear crosspiece between upper arms.
NOTE: Deburr inside
of tarp tube or outside
of elbow if elbow will
not easily slide into
tarp tube.
STEP 2: Lay assembled tarp tube on flat surface with ends of
tube laying flat and facing same direction. Drill two
5/16" holes on tarp tube side of joint. Fasten with
shoulder bolt
B
assembled
tarp tube
9
6"
and tee nut
.
K
5/16"
drill
hole
B
K
face both ends of tarp
tube in same direction
1
2
K
STEP3:
Slide rubber bumpers onto upper arm. Push bumpers
as far into bends as possible.
upper
arm
rubber
bumper
P/N 1809533 Rev. B
4
B
5
1
rear
crosspiece
push bumbers
into bends
STEP 4: Feed rear crosspiece
through pocket on rear end
of tarp. Reassemble tarp
tarp pocket
tube and elbow. Fasten
with shoulder bolt
tee nut
B
K
rear
crosspiece
3
rubber
bumper
upper
arm
and
B
.
K
rubber
bumper
upper
arm