DoorHan DHRE-2 Manual de instalación - Página 2

Navegue en línea o descargue pdf Manual de instalación para Receptor DoorHan DHRE-2. DoorHan DHRE-2 3 páginas. External radio
También para DoorHan DHRE-2: Manual de instalación y funcionamiento (3 páginas), Manual de instalación y funcionamiento (3 páginas), Manual de instalación y funcionamiento (2 páginas)

DoorHan DHRE-2 Manual de instalación
Ec DEclaRatIon of confoRMItY
We: DoorHan Europe s.r.o.
Bozeny Nemcove 1689, 43201 Kadan, Ceska Respublika Herewith declare
under sole responsibility that:
additional note:
These products have undergone tests in a typical uniform configuration
(all products manufactured by DoorHan Europe s.r.o.)
01/03/2010
Date
1. DEscRIptIon
External receiver DHRE-2 is meant for receiving radio remote control signal
with 433 MHz frequency, decoding it and control signal actuating.
2. tEcHnIcal spEcIfIcatIons
operating frequency. (MHz)
power supply. (V. ac Dc)
Max. load current. (nia)
Max. number of transmitters
number of channels
operating ambient temperature (°c)
3. InstallatIon
1. Connect your receiver to a power supply 12/24 V, AC/DC by using input
terminals +24V and GND.
2. Connect the operator control board N.O. operating inputs to receiver
output terminals CH1 or CH2.
Memory clearing
3. Before encoding you can clear the receiver memory from the previously
stored codes (it is recommended at the first setting). To perform it, when the
power is switched on, press CODE button for the 10 seconds (CODE1 (or SW1)
- if you are using CH1, CODE2 (or SW2) - if you are using CH2). LED1 will be
flashing 10 seconds then switch off for 2 seconds and flash twice to confirm
that the memory is clear.
Encoding
4. For encoding a transmitter code to the receiver press CODE button for
3 seconds on the receiver board (CODE1 (SW1) for the operator connected
to CH1 and CODE2 (SW2) for the operator connected to CH2) LED1 will light.
After that press a button on the transmitter twice.
attention! After this operation only 1 button of the transmitter is stored
in the receiver memory.
5. For encoding another transmitters repeat the procedure.
4 Connection
For connection a receiver to a control board it is needed to connect the
output control terminals (CH1 or CH2) and the power supply terminals (+24V,
GND) to a control board.
• Declares that: The device model Reciever outside 433MHz
2 channels (DHRE-2)
• Сomplies with the essential safety requirements of the fol-
lowing directives:
73/23/EEC and subsequent amendment 93/68/EEC
89/336/EEC and subsequent amendment 92/31/EEC
and 93/68/EEC
Mikhail Kiselev
InstallatIon Manual REcIEVER
outsIDE 433MHz 2 cHannEls
(DHRE-2)
Managing Director
signature
433
12/24
60
115
2
-20..+50