DoorHan DHRE-2 설치 매뉴얼 - 페이지 2

{카테고리_이름} DoorHan DHRE-2에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DoorHan DHRE-2 3 페이지. External radio
DoorHan DHRE-2에 대해서도 마찬가지입니다: 설치 및 운영 매뉴얼 (3 페이지), 설치 및 운영 매뉴얼 (3 페이지), 설치 및 운영 매뉴얼 (2 페이지)

페이지 인쇄

Ec DEclaRatIon of confoRMItY

We: DoorHan Europe s.r.o.

Bozeny Nemcove 1689, 43201 Kadan, Ceska Respublika Herewith declare

under sole responsibility that:

additional note:

These products have undergone tests in a typical uniform configuration

(all products manufactured by DoorHan Europe s.r.o.)

01/03/2010

Date

1. DEscRIptIon

External receiver DHRE-2 is meant for receiving radio remote control signal

with 433 MHz frequency, decoding it and control signal actuating.

2. tEcHnIcal spEcIfIcatIons

operating frequency. (MHz)

power supply. (V. ac Dc)

Max. load current. (nia)

Max. number of transmitters

number of channels

operating ambient temperature (°c)

3. InstallatIon

1. Connect your receiver to a power supply 12/24 V, AC/DC by using input

terminals +24V and GND.

2. Connect the operator control board N.O. operating inputs to receiver

output terminals CH1 or CH2.

Memory clearing

3. Before encoding you can clear the receiver memory from the previously

stored codes (it is recommended at the first setting). To perform it, when the

power is switched on, press CODE button for the 10 seconds (CODE1 (or SW1)

- if you are using CH1, CODE2 (or SW2) - if you are using CH2). LED1 will be

flashing 10 seconds then switch off for 2 seconds and flash twice to confirm

that the memory is clear.

Encoding

4. For encoding a transmitter code to the receiver press CODE button for

3 seconds on the receiver board (CODE1 (SW1) for the operator connected

to CH1 and CODE2 (SW2) for the operator connected to CH2) LED1 will light.

After that press a button on the transmitter twice.

attention! After this operation only 1 button of the transmitter is stored

in the receiver memory.

5. For encoding another transmitters repeat the procedure.

4 Connection

For connection a receiver to a control board it is needed to connect the

output control terminals (CH1 or CH2) and the power supply terminals (+24V,

GND) to a control board.

• Declares that: The device model Reciever outside 433MHz

2 channels (DHRE-2)

• Сomplies with the essential safety requirements of the fol-

lowing directives:

73/23/EEC and subsequent amendment 93/68/EEC

89/336/EEC and subsequent amendment 92/31/EEC

and 93/68/EEC

Mikhail Kiselev

InstallatIon Manual REcIEVER

outsIDE 433MHz 2 cHannEls

(DHRE-2)

Managing Director

signature

433

12/24

115

-20..+50