Canon PIXMA MX870 Series Manual de configuración de red - Página 11

Navegue en línea o descargue pdf Manual de configuración de red para Impresora todo en uno Canon PIXMA MX870 Series. Canon PIXMA MX870 Series 16 páginas. Setting up in default mode (tel priority mode) without an answering machine
También para Canon PIXMA MX870 Series: Manual de instalación (17 páginas), Manual de instalación (11 páginas), Manual de configuración de red (34 páginas), Folleto (2 páginas), Manual de instalación en red (24 páginas), Manual de instalación en red (17 páginas), Manual de instalación (15 páginas), Puesta en marcha (15 páginas)

Imprimir página
Canon PIXMA MX870 Series Manual de configuración de red
Entering the Access Point's Wireless LAN Settings Directly on the
Machine
Action
Enter the access point name/network name (SSID) and security setting (WEP, WPA,
etc.) on the machine directly.
Follow the procedure below.
1
Press the Setup button.
2
Use the [ or ] button to select Wireless LAN Setup,
then press the OK button.
3
Select Yes, then press the OK button.
•
When wireless connection is enabled, the Wi-Fi lamp lights
blue.
4
Use the { or } button to select Other setup, then
press the OK button.
5
Select Advanced setup, then press the OK button.
6
Select Directly enter the access point name, then
press the OK button.
•
If you are living in an apartment, nearby access points in use
may be detected.
7
Enter the access point name/network name (SSID)
using the Numeric buttons, then press the OK button.
For details on how to enter characters, refer to "Character
Entry" on page 8.
•
Enter the same access point name/network name (SSID) as
that of the access point on the machine.
•
For details on how to check the access point name/network
name (SSID), refer to the manual supplied with the access
point or contact its manufacturer.
•
Enter upper and lower case letters of the alphabet correctly. Letters are case sensitive.
8
Make sure that the access point name/network name
(SSID) is correct, then press the OK button.
9
Select a security protocol for the access point, then
press the OK button.
•
Go to either of the following steps according to the selected
security protocol.
Disable
Go to
WEP
Go to
WPA/WPA2
Go to
•
When WEP 40 bit or WEP 128 bit is selected in AirPort Utility (AirPort Admin Utility), select
WEP.
•
When WEP (Transitional Security Network) is selected in AirPort Utility, select WPA2-PSK
(AES).
on page 10.
on page 10.
on page 10.