Flybar 1200 Manual de instrucciones - Página 3

Navegue en línea o descargue pdf Manual de instrucciones para Columpio Flybar 1200. Flybar 1200 8 páginas.

Stay within your abilities

With experience and skill, you'll be able to react to pretty much any situation reflexively. But skill develops slowly, so take your time. As you put in

the hours, you'll become instinctively aware of how much traction you have, how high you're going to bounce, how to correct for balance, and

where you're going to land. Be prepared to bail out at any time.

ASSEMBLY

For the most part, your Flybar 1200 comes pre-assembled. All you have to do is attach the handlebar

assembly cap to the top of the outer shell. Use the included 5mm Allen key and attach the handlebar

clamp to the metal plate by tightening the four bolts on the top cap into the corresponding holes on the

metal plate. Be sure to remove the four black boots that are used to keep the bolts in place during shipment.

Bolts are to be tightened incrementally in a proper order to ensure a firm grip on the handlebars.

SETUP AND ADJUSTMENT

Before using your Flybar 1200, you'll need to adjust it to suit your weight, skill level and goals. This involves two key decisions: how many

thrusters to engage and how long to set the piston. Before we go any further, remove the shell. Use the end of the Flybar Tool marked "A"

to loosen and remove the six bolts near the bottom of the shell. Now, take a good look at the Flybar 1200's guts.

Partially tighten bolt 1, then 2,

then 3, and then 4. Repeat the sequence

until all the bolts are fully tightened.