Ametek Crystal Pressure WT Series Manual de instrucciones - Página 3
Navegue en línea o descargue pdf Manual de instrucciones para Equipos de prueba Ametek Crystal Pressure WT Series. Ametek Crystal Pressure WT Series 19 páginas. Digital test gauge
Imprimir páginaOverview
INTRODUCTION
Thank you for choosing the WT Series Digital Test Gauge from Crystal Engineering Corporation. The WT Series is a combination of leading edge technol-
ogy and rugged industrial design. The WT Series Digital Test Gauge is designed to fit in 8" or 10" panel mount applications commonly found in portable test
sets. The WT Series is based on the Crystal Engineering Corp. model XP2i digital pressure gauge (www.xp2i.com). The WT Series pressure gauge has been
repackaged so that it may be mounted in a portable enclosure, while retaining easy access to batteries and to the digital (RS-232) interface (both of which
would otherwise be on the back of the gauge).
Accuracy is 0.1 percent of reading–so any WT Series can typically replace several gauges you may have been using. The WT Series is fully temperature compen-
sated–so there is no change in accuracy throughout the entire operating temperature range!
The WT Series' case is made from rugged aluminum alloy utilizing a gasket to seal the enclosure against dust and water intrusion. Even the RS-232 connector
is fully sealed (with or without the red cover or rubber boot). Circuitry is mounted in shock absorbing elastomer supports and the batteries are easily acces-
sible by removing four screws. But you won't need to change the batteries often, since 3 AAA batteries provide up to 500 hours of continuous operation. The
batteries are easily replaced by removing the two screws. Other features include:
•
Continuous capture of peak and valley pressure readings
•
PSV mode
•
Programming interface
•
User-defined units
•
All welded 316 stainless steel sensor
We hope your WT Series meets your expectations, and we're interested in any comments or suggestions you may have. You can send us a note at:
[email protected]. Many features in this and our other products are a direct result of your comments!
Crystal Engineering is the company that designs, manufactures, markets, and services the nVision reference pressure recorder, XP2i, and 30 series pressure
calibrators, M1 Pressure Gauge, MultiCal multimeter pressure adapters, and a variety of industry specific pressure measuring equipment. Crystal Engineering
pioneered features like full temperature compensation and "of reading" rated gauges and calibrators. Pressure measuring equipment is the only thing we do
and that's why we say:
™
Overview
Your WT Series can be customized, through
the use of our free ConfigXP™ software. Your
personal computer can disable, enable, or
modify a variety of features of your XP2i. Look
for the
logo
for programmable features, like:
•
A user defined pressure scale, and/or disable
unused pressure units
•
Password protection to prevent
unauthorized changes
•
(
)
peak
Disable keypad recalibration,
(
)
button, and/or
units
button
•
Expand or decrease allowable Zero range
•
Set the gauge to a different density of water
factor (4° C, 60° F, or 68° F)
•
Store a 12 digit ID or tag number in
non-volatile memory
•
Adjust calibration values
XP2i Operation Manual
1