Ametek Crystal Pressure WT Series Manual de instrucciones - Página 5

Navegue en línea o descargue pdf Manual de instrucciones para Equipos de prueba Ametek Crystal Pressure WT Series. Ametek Crystal Pressure WT Series 19 páginas. Digital test gauge

Imprimir página

Functions

Units Button

units

Pressing this button causes the WT Series to select the next available unit of pressure measurement.

Pressure Ranges, Display Scales, & Resolution on page 12

See

Units that you don't need or never use can be turned off. You can also define a special unit for your WT Series with ConfigXP.

You can use the WT Series to display directly in a unit not otherwise available, such as feet of seawater, or foot-pounds of torque. When you select your custom

unit from the keypad, the screen displays the USER icon.

Peak Button

peak

(

)

Pressing the

peak

button causes the display to cycle through the following , depending on your setting in ConfigXP.

<No Icon> . . . . Live Pressure display

. . . . Maximum detected pressure

. . . . Minimum detected pressure

(blinking)

. . . . PSV Mode, maximum

(blinking)

. . . . PSV Mode, minimum

. . . . Average pressure

. . . . DataLoggerXP datalogging mode

From the factory this setting is disabled. Use ConfigXP to enable.

Peak High and Peak Low values are not saved when the gauge shuts off; they will reset to the current reading when the WT Series is turned on or reset.

In some cases the ability to display a peak value may not be needed, or may even be dangerous. ConfigXP allows you to disable this button.

The WT Series can average 1 to 10 readings, recalculated every time pressure is measured (4 times per second). Enable and set the number of readings to be averaged with ConfigXP.

or the list of pressure units available for your model.

Functions



XP2i Operation Manual