Astrol Electronic BAT-FLEX Manual - Página 6

Navegue en línea o descargue pdf Manual para Instrumentos de medida Astrol Electronic BAT-FLEX. Astrol Electronic BAT-FLEX 19 páginas.

2.5.2.3.

Warnings



Do not plug the Ethernet cable into the JTAG connector. The connectors have different pin counts, however, because of the RJ

standard, they look very similar.

Astrol Electronic AG reserves the right to change specifications without notice

Bat FLEX Manual

This screen is used to update the BatFlex network configuration.

To enter the dialogue, push the button once. Parameters can be

adjusted by rotating the wheel. To advance to the next parameter,

press the button once again. The active field will light up in red.

This page is used to keep the system up to date. All device users

will be notified if an important update is available.WARNING: This

section is reserved for experienced users, wrong updating could

damage the device.

FPGA-IMG from SD:

Firmware from SDCard:

Firmware from RAM

Config-Flash reset

6/19

A new FPGA image will be

transferred from the SD card to

the device. This is a major update,

which means that the entire

software is renewed.

The FPGA boots up several soft

cores during runtime. This section

updates the soft core firmware.

The

FPGA

programming

remain.

Code can be loaded dynamically to

the device RAM. This function will

copy the running code into

persistent memory. Please note

that this section should be used by

developers only.

Configuration is set to default and

will be rebuilt.IP address and Port

will be set back.

AD-10069-007 Rev. 03

will