Astrol Electronic BAT-FLEX Manual - Page 6
Browse online or download pdf Manual for Measuring Instruments Astrol Electronic BAT-FLEX. Astrol Electronic BAT-FLEX 19 pages.
Print Page
2.5.2.3.
Warnings
Do not plug the Ethernet cable into the JTAG connector. The connectors have different pin counts, however, because of the RJ
standard, they look very similar.
Astrol Electronic AG reserves the right to change specifications without notice
Bat FLEX Manual
This screen is used to update the BatFlex network configuration.
To enter the dialogue, push the button once. Parameters can be
adjusted by rotating the wheel. To advance to the next parameter,
press the button once again. The active field will light up in red.
This page is used to keep the system up to date. All device users
will be notified if an important update is available.WARNING: This
section is reserved for experienced users, wrong updating could
damage the device.
FPGA-IMG from SD:
Firmware from SDCard:
Firmware from RAM
Config-Flash reset
6/19
A new FPGA image will be
transferred from the SD card to
the device. This is a major update,
which means that the entire
software is renewed.
The FPGA boots up several soft
cores during runtime. This section
updates the soft core firmware.
The
FPGA
programming
remain.
Code can be loaded dynamically to
the device RAM. This function will
copy the running code into
persistent memory. Please note
that this section should be used by
developers only.
Configuration is set to default and
will be rebuilt.IP address and Port
will be set back.
AD-10069-007 Rev. 03
will