AKW MediCare 3000 Series Instrucciones de instalación y cuidado
Navegue en línea o descargue pdf Instrucciones de instalación y cuidado para Equipamiento médico AKW MediCare 3000 Series. AKW MediCare 3000 Series 2 páginas. Seats
Imprimir página
AKW MediCare
Colour: White to RAL 9016 / Grey to RAL 7035
Shower Seat Use
The Shower Seat must only be used for the tasks it is intended to perform.
Do not stand on it or misuse it. This may have serious detrimental effects on
its performance and safety.
The Shower Seat should be checked as part of a planned maintenance
programme.
Children and other users may require
supervision when using this product.
Keeping your AKW
Shower Seat Clean
This product should be cleaned
periodically to remove any accumulation of
hair or other waste material, using normal
domestic bathroom cleaning materials. After
cleaning always flush down with water then wipe
thoroughly with a damp cloth to remove any
cleaning material residues before drying off.
Disinfecting
Where disinfecting is necessary, standard established procedures for
disinfecting equipment should be used with due care and attention taken of the warnings concerning possible effects of
aggressive chemicals on plastics.
After cleaning always flush down with water then wipe thoroughly with a damp cloth to remove any cleaning material
residues before drying off.
Do not use strong or concentrated acidic, alkaline or other cleaning materials as these may discolour or damage the product.
AKW does not approve or recommend autoclave cleaning due to the damage this can cause to the special engineering
plastics used in the construction of this product.
Packaging
This Shower Seat is supplied in a polypropylene (PP) bag to keep the product unsoiled until installation; it may also be
packed in a cardboard box.
Both are suitable for recycling operations and should be disposed of in accordance with local recycling regulations.
Cushion Assembly
Fig.1
Fit Hole Reducers to
4 or 8 HOLES if cushions
are not used. (Fig.1)
Installer: Please ensure that this information is left with the end user of this product.
3000 Series Seats
User care instructions
To fit cushions remove hole reducers (if fitted).
Push lugs on cushion into holes in the seat. (Fig.2)
(Cushions are not recommended for regular side-transfer unless
replaced when lugs wear out or split.
Contact AKW for details of side transfer cushion kits)
Internal Building use only
Fig.2
Reg Designs:
GB 3011016/7
EU 000062047-0001/2
US D510487
US D501611
US D494767